Wireless Signal Detector Probe (50MHz to 3.5GHz)
This RF Strength Meter monitors high frequency radiation
in the 50MHz to 3.5GHz range. Ideal for detecting cellular,
transmission, base stations, locating RF hotspots, wireless
network (Wi-Fi) RF detection, RF"Electrosmog" detection,
and microwave leakage. It features non-directional
measurement with 3-channel (triaxial) measurement probe,
Max Hold and Average functions, and manual store/recall
of up to 99 data sets.
In addition, there is an audible alarm with a
user-selectable threshold. The meter comes complete
with a 9V battery and carrying case.
Easy to use steps:
1 use indoor or outdoor, Scan radioactive source from 50MHz to 3.5GHz.
2, turn off all the electronic equipment, Please do not unplug the power
cord for any equipment, just turn it off, if it is a vehicle, please
leave the motor running.
3, turn on the WSD-1, stay still for about 5 minutes, watch the LCD
display reader, If the reader's value changed regularly, If may have a
device in your room or in your vehicle.
4, if the reader's value stay same when you still watch the LCD display
within five minutes, you can start walk around you house/office/room,
point the probe's Z axial to different direction, if you see the reader
has higher value on certain spot or certain direction, you can use the
probe do a close inspection.
in the 50MHz to 3.5GHz range. Ideal for detecting cellular,
transmission, base stations, locating RF hotspots, wireless
network (Wi-Fi) RF detection, RF"Electrosmog" detection,
and microwave leakage. It features non-directional
measurement with 3-channel (triaxial) measurement probe,
Max Hold and Average functions, and manual store/recall
of up to 99 data sets.
In addition, there is an audible alarm with a
user-selectable threshold. The meter comes complete
with a 9V battery and carrying case.
Easy to use steps:
1 use indoor or outdoor, Scan radioactive source from 50MHz to 3.5GHz.
2, turn off all the electronic equipment, Please do not unplug the power
cord for any equipment, just turn it off, if it is a vehicle, please
leave the motor running.
3, turn on the WSD-1, stay still for about 5 minutes, watch the LCD
display reader, If the reader's value changed regularly, If may have a
device in your room or in your vehicle.
4, if the reader's value stay same when you still watch the LCD display
within five minutes, you can start walk around you house/office/room,
point the probe's Z axial to different direction, if you see the reader
has higher value on certain spot or certain direction, you can use the
probe do a close inspection.
